Elevator Forum

elevatedone
@elevatedone
Estimable Member
Joined: Jan 1, 2010
Topics: 16 / Replies: 116
Reply

They are all scoundrels in my book.Hence the unemployment.I wouldn't dream of going to a local where there are still people on the bench.I have seen i...

13 years ago
Forum
Reply

What do you need troubleshooting?It is my calling,it's what I live to do.When they put me on a route ,I degrade because of boredom. Adjusting is easy,...

13 years ago
Forum
Topic
Forum
Replies: 14
Views: 27302
Reply

Did your company provide any technical support when they acquired the job?My opinion is if a company gets a unit without any books or support,it is no...

13 years ago
Reply

That is what you call job security,my friend.;)

13 years ago
Reply

That would have been great a few months ago.But I have since been laid off,so no longer my problem.Looking into getting into robotics at the moment si...

14 years ago
Reply

You unlucky bastard.Do you know if it was upgraded to the lrv 4?That would be the pc controller behind the cop.Check your door locks,gate switch and c...

14 years ago
Reply

Well,you could make your own,but it wouldn't do any good.You really think they would pay attention to that??Do they pay attention to those signs on th...

14 years ago
Reply

How new?They have changed the controllers to were if you access the car top and don't follow the car top access procedure,it shut's the unit down with...

14 years ago
Reply

You would get a fault.Say it was parking at the top level,and it would relevel thus hitting the limit would give you a fault.Door timing out would giv...

14 years ago
Reply

Go through your door locks.And check to make sure your traveling cable is ok and not hitting something in the hoistway and grounding out.It's a start,...

14 years ago
Reply

Definitely needs a service tool,check your messages.

14 years ago
Reply

No manual,but all from memory.M-1-1-1 gives you the status of the car.fisrt part on the left would be car position then status of the car,to the right...

14 years ago
Reply

Try this,a large selection.

14 years ago
Reply

It is called an amp connector.There are t-handled insertion tools and also a gun version.This is a link but having a hard time finding the right tool....

14 years ago
Page 2 / 9
Scroll to Top