Elevator Forum

To be honest I don't have much experience with these. I have a "cheat sheet" from our local Local that has stop ring and inspection terminals to jump ...

Tc6 to tc13 upTT1 to TT9 up limit

Good find, thanks for letting us know the solution

No idea on PTL fixtures. But maxtons are really good valves too. Half the hydros on my route have maxtons. I'm just a little partial to Blain because ...

Don't take the incoming power for granted.. I find in cases like this using my fluke 115 on min/max set to minimum voltage put into a specific point i...

Be sure the retainer clips are on all the relays. It's also worth noting the finder and schrack relays seem to have different thickness pins, can't re...

I'm not a huge fan of smartrise. I have enough of them on my route to have dealt with alot of issues with smartrise stuff. They're geared towards maki...

They are nothing more than tin can ticking time bombs. They run good for awhile then....

Depending on what was used before it may be worthwhile to clean the tracks with brake cleaner before using the new lube. Red brake cleaner (chlorinate...

I have had very good success using wd-40s "specialist" silicone lubricant. Id highly recommend it. It's my go to for most light duty lubricating needs...

If its that old you might have lost your Dallas chip. If that's the case you'll need a new one then have to go back through and check your parameters ...

Personally I don't have any experience with them. There's not many around here, I've only seen one once. That being said, I think you can't be the bes...

Definitely would be removing proprietary equipment and installing a VA controls MH-3000 controller with an interface products selector and gal movfr o...

My apologies, the way you'd worded your first post seemed like similar posts by building owners.

I would recommend calling a local elevator company to have them service it.