Elevator Forum

Have you looked in the a17.6?

Have you called them? Va controls are some great folks. Easy to get ahold of. Have the controller job number when you call, that's all.

Keep talking to MCE, write down names of who your talking to and try getting someone different each time. I have a job of 7 ibox cars, 500 fpm gearles...

Another option would be straps around the crosshead to the hoist beam in lieu of either the stands or rail blocks

Rail blocks. If I was doing that job, I would use pipe stands and rail blocks. And then hang a fall off the bottom of the car.

Tallest one was a 6 stop, three 5 stops.

I'm not an Otis guy and you're correct you're missing alot of info. But, Otis had to have run buttons to install it no matter what controller it is. S...

What state are you in you have to have an acceptance test done after replacing a drive?

We just installed a MEI freight car. Overall not bad, but I wasn't impressed with the amount of missing parts. I have no experience with a roped hydro...

The Canton is best paired with a Virginia controls MH-3000 controller in my opinion. Gives it that run for 50 years type of reliability.

I have installed some roped hydro Canton packages and maintain some others have installed. I would say the number one critical factor here is install ...

If you end up needing a new PLC or other NWOV parts, call American access industries at 816-997-9317.

Good catch. Install quality goes a long way towards reliability for sure

I would rip the whole thing out and replace with a gearless torin/SES machine and an ibox controller. Elsom, how come yall didn't just use a step up i...

Two day prime shipping to boot...