Elevator Forum

I sent some prints to your email. Not great quality but may help.

After replacing the dallas chip, programming the parameters again, it took a dozen tries to get the shaft learn to finally take and the shaft communic...

When we checked 4-1 it comes back as 4-1-10 OSS. Wońt go into normal. Is there a “floor table” that has to be set / reset

For some reason the shaft setup won't start. Drove the car down to thelowest landing. 61U, 77N, 77S, 30, are lit. 5-2 set to 1, turned RDF to norm but...

We we able to weigh the machine. It weighed 1152 lbs. The deflector sheave weighed 236 lbs. For anyone else that may require these numbers.

We ended up replacing the AMD 1.5 board and motor with a Midi/Supra board and motor. Everything works as it should now.

We have ordered a couple new FCB boards and will try things again once we are back on site. Hopefully new boards and multiple lon downloads will kick ...

We have ordered new FCB boards and will see what that is our problem

We just did a mod on a MX20! Direct bolt in place machine from imperial. MCE controller. Retained the Wittur door op. Easy mod!

If you place the controller on inspection fault bypass (F3 menu) you should be able to move if the safety circuit is made up and doors are locked. Unl...

Checked the termination resistor and its ok. Not getting the 0169 fault as the battery monitoring has been turned off. We are working on an eco.