Elevator Forum

Otis Noisy Brakes
 
Notifications
Clear all

Otis Noisy Brakes

6 Posts
4 Users
0 Reactions
5,476 Views
(@administrator)
Honorable Member
Joined: 17 years ago
Posts: 386
Topic starter   [#636]
Otis Noisy Brakes

My customer is complaining that these brakes are too loud when picking. It looks like the strike points are metal on metal when picking that's causing the noise. Is there some trick to quite these down or are they just typically loud?


   
Quote
 E311
(@e311)
Reputable Member
Joined: 17 years ago
Posts: 363
 
There may be too much clearance between the shoes and the drum when the brake is picked. The farther it picks the more noise you will have. Make sure your brake pick and hold voltages are not too high and the switches open early in the cycle

Last edited by E311; 08/21/10 05:59 PM.


   
ReplyQuote
(@administrator)
Honorable Member
Joined: 17 years ago
Posts: 386
Topic starter  
The clearance is very tight. I think they may have too much spring pressure on the arms as well. I think I need to take test weights out there and start from scratch. I was just curious if this brake is noisy even when set-up correctly. These machines sit directly above a 3 million dollar penthouse with no sound isolation. You gotta love the logic in that decision.



   
ReplyQuote
 E311
(@e311)
Reputable Member
Joined: 17 years ago
Posts: 363

   
ReplyQuote
(@j-sand)
Estimable Member
Joined: 17 years ago
Posts: 100
 
Looks like an 18 ATF machine? they are inherentley noisy. And more than likely were not "fine tuned" when installed. Take a look at the air gap on the plungers. Too much will cause the plungers to slam open. you should be able to get some, but not all of the clap out. i would try that first before resetting your ETS/125% brake spring pressure : )



   
ReplyQuote
(@greenpants)
Reputable Member
Joined: 17 years ago
Posts: 276
 
make sure that when the core picks that the whole plate is flush the the core. usually the the top is .9mm and the bottom is around .8mm. too much gap causes the loud clap. also check pick voltage a lot of jobs were never adjusted right and the pick voltage is too high.



   
ReplyQuote
Share:
Scroll to Top