Notifications
Clear all
Topic starter
02/10/2020 3:48 am
Hey guys,
Tomorrow I am being sent to replace a 330a Criphna controller board that had some defective relays. Is it a matter of unplugging the old and plugging in the new board or will it need to be reprogrammed with job parameters? Thanks for any help
Tomorrow I am being sent to replace a 330a Criphna controller board that had some defective relays. Is it a matter of unplugging the old and plugging in the new board or will it need to be reprogrammed with job parameters? Thanks for any help
02/10/2020 4:03 am
The cpu is on the other board that plugs into the crip board vertically. If the software is good and that vertical board is good then you do no need to do any programming
Topic starter
02/10/2020 4:17 am
Thanks Jluff that was quick. I really appreciate it.