Notifications
Clear all
Topic starter
16/08/2012 9:20 pm
This unit keeps blowing the controller s15 3 amp fuse. When we disconect all of the terminal plugs from the CIO car station board- the fuse holds. Where is the best place to get this board? Do i need any programming tool or is it just a swap? Thanks. Sr.
17/08/2012 7:09 am
Adams,maybe.or SEES.
21/08/2012 10:12 am
Yep common problem. No tool needed straight swap just check the software chip and the right version board.
Last edited by Wrench; 08/21/12 02:13 AM.
22/08/2012 7:20 am
Had a problem with a fuse blowing on the CRIPHNA board. Would not blow when powering up on inspection,flip to auto and fuse would blow. Found a shorted thermal in the motor. Temp. Disconnected thermal, replaced motor eventually.
24/08/2012 2:43 am
Scott
You could try Mike Tuttle @ ECI America or Sean @ World Electronics. Adams is owned by Schindler but I have found their prices to be much higher.
You could try Mike Tuttle @ ECI America or Sean @ World Electronics. Adams is owned by Schindler but I have found their prices to be much higher.
09/10/2012 9:44 am
IT COULD BE YOUR CAR DIRECTIONAL LATTERN BLOWING THE FUSE.PLUG IN ONE AT A TIME TILL IT BLOWS.THEN TRACE