Elevator Forum

Resolve 100 DRIVE I...
 
Notifications
Clear all

Resolve 100 DRIVE Issue

6 Posts
3 Users
0 Reactions
5,534 Views
(@dayton71180)
Active Member
Joined: 17 years ago
Posts: 8
Topic starter   [#23660]
All,

I have a KONE Resolve 100 that is giving me a Start Current Fault. Has anyone ran into this issue. Had DRIVE checked out and it is good. Checked all incoming power as well as connections and Parameters. Any help would be appreciated!!



   
Quote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798

   
ReplyQuote
(@dayton71180)
Active Member
Joined: 17 years ago
Posts: 8

   
ReplyQuote
 BRG
(@brg)
Reputable Member
Joined: 17 years ago
Posts: 169

   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
the fault code says that the fault was generated to the computer by the 3rd party Drive. It was reported to the MCUYAS board. So very vague as to what is happening.



   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
One other note, the fault was generated because the computer detected a voltage at the motor when it should been at floor level and the run completed. So it may be happening at the end of the run and not the beginning. Not sure though, just something to look at.



   
ReplyQuote
Share:
Scroll to Top