Elevator Forum

Load Weight Device ...
 
Notifications
Clear all

Load Weight Device of Kone

8 Posts
4 Users
0 Reactions
14.5 K Views
(@jet-g)
Active Member
Joined: 17 years ago
Posts: 8
Topic starter   [#14466]
Hello guys, i have a problem with LWD device in a Kone elevator. The problem is that when i try to adjust the value of weight its shows a value 124, when i try to adjustment the value doesnt change. I have checked tha cabld of LWD and it is ok. Where the problem may be, and have anyone of you know this kind of problem



   
Quote
 jkh
(@jkh)
Prominent Member
Joined: 17 years ago
Posts: 904

   
ReplyQuote
 BRG
(@brg)
Reputable Member
Joined: 17 years ago
Posts: 169
 
How are you trying to adjust it? What type of kone system is it?

Originally Posted By: jet_g
Hello guys, i have a problem with LWD device in a Kone elevator. The problem is that when i try to adjust the value of weight its shows a value 124, when i try to adjustment the value doesnt change. I have checked tha cabld of LWD and it is ok. Where the problem may be, and have anyone of you know this kind of problem



   
ReplyQuote
(@jet-g)
Active Member
Joined: 17 years ago
Posts: 8
Topic starter  
it is kone monospace and i try to adjust in the parameter 5 1 moving the OFFSET

Last edited by jet_g; 06/19/15 07:24 PM.


   
ReplyQuote
(@jet-g)
Active Member
Joined: 17 years ago
Posts: 8

   
ReplyQuote
 BRG
(@brg)
Reputable Member
Joined: 17 years ago
Posts: 169
 
The monospace uses a sensor under the car that is set to a certain gap between the sensor and a piece of steel mounted to the isolation platform for a zero reference. You have what sounds like an ecospace. It probably has a small board mounted inside of the controller. If the jumpers are in the wrong configuration you will not be able to set the loadweigher. If the cpu is seeing 124% load then you're not going to be able to run on automatic, it thinks it's overloaded. BTW 5-1 is a read-only parameter.

The strain gauge is mounted on the dead-end hitch in the top of the hoistway.



   
ReplyQuote
(@jet-g)
Active Member
Joined: 17 years ago
Posts: 8
Topic starter  
the strain gauge is that mounted in the rope fixing.
in the menu 5-1 just i read the value to try to adjust with offset thats in the map controller.
Please can you tell me about the small board iside the controller where is it and which jumpers i should check.

thank you



   
ReplyQuote
(@elev-te79)
Estimable Member
Joined: 17 years ago
Posts: 116

   
ReplyQuote
Share:
Scroll to Top