Elevator Forum

Notifications
Clear all

KCM fault 166 & 164

4 Posts
2 Users
0 Reactions
4,085 Views
(@elev-te79)
Estimable Member
Joined: 17 years ago
Posts: 116
Topic starter   [#9795]
Getting a 166 fault followed by a 164 fault that shuts the elevator down . Happens intermittently . Changed ADON board and did an ADON learn . Any suggestions ?



   
Quote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
166 is a is a re-leveling too fast fault.the code says k-486 relay dropped while leveling with the doors open. k-486 drops at speeds of .65m/sec and higher. you can check the speed at ui:5.20.9, it should be 65. 164 is a k486 failed to pick when the car is stopped fault.



   
ReplyQuote
(@elev-te79)
Estimable Member
Joined: 17 years ago
Posts: 116

   
ReplyQuote
(@john-jay)
Prominent Member
Joined: 17 years ago
Posts: 798
 
If the problem is intermittent and you have replaced the ADON Board, I think you should check the Brakes. You should have 1/4 inch of thickness on the linings, and the Flat Washer under the center adjusting Nut should be movable by hand. Perhaps someone puts a heavy load on ounce in a while and you are slipping through the Brake. Putting a full load on would be a good way to see if you are holding with the Brakes. It is also possible you have gotten a bad ADON from Spares. A not unheard of scenario.



   
ReplyQuote
Share:
Scroll to Top