Notifications
Clear all
01/03/2016 8:35 am
Hello
I did not see reply LED on CPU board.
Check 5 volt supply. Make sure no ac ripple.
I did not see reply LED on CPU board.
Check 5 volt supply. Make sure no ac ripple.
04/03/2016 9:10 am
If software chip is fried then you will not have LED on either. Just had that happen.
Topic starter
30/03/2016 9:15 am
I have the red light on cpu all lights on door boards all communication back ul to ims ever resistance checks out good. Loaded all parameters from car in duplex back tk this car but the doors dont open for the learn and the selector says no data after i do all steps to learn hoistway????
30/03/2016 11:04 pm
Hi, I was told on the DMC you have to turn on a parameter to enable save mode. Not sure if that is true or not. Any one know?
Topic starter
31/03/2016 6:11 pm
We got the selector and rear door setup the front doors works but trys to open on 1st floor were there is no opening, this happens when you place a car call to upper floor, also if you place car call to first floor the car goes to top if hoistway
31/03/2016 11:09 pm
Have you set of the landing is a front or rear opening? Confirm how many landing is program.
01/04/2016 4:21 am
Did you enter all parameters correctly. You have to Validate proper front and rear floors.
01/04/2016 4:49 am
Anyone know why this miprom 21 won't go off fire service
01/04/2016 3:07 pm
if you have more than one car in the same bank.you can upload the parameters from a working car from the clc ..and than download it back into the car not working..as long as they have the same characteristics..all you have to change in the final stage is make sure you keep the master/slave designation the same...no hoist scan needed..usually will have a running car back in group in no time....
26/04/2016 11:45 am
Floor validation for doors wrong on that DMC , recheck your chart.
12/05/2016 10:06 am
Check parameter 52 and 56 in CLC
Page 2 / 2
Prev