Elevator Forum

Notifications
Clear all

330A question

3 Posts
3 Users
0 Reactions
2,301 Views
(@bills)
Estimable Member
Joined: 17 years ago
Posts: 81
Topic starter   [#29285]
I have a few questions about working with the 330A.
Can everything with these be managed from the controller ? (not the hydraulics, of course)
Can any parameters be changed or does one then need new software from Schindler if you need to make a change?
Are all menus and submenus accessible?

Are there any special tools needed?

Are there occasions when the controller locks up and cannot be reset without going back to Schindler?



   
Quote
(@jblack83)
Estimable Member
Joined: 17 years ago
Posts: 143
 
It has a user interface tool. Default password is a b c d. Any 94 faults require the controller to be put on inspection prior to reset to clear the fault



   
ReplyQuote
(@ilikeelevs)
Eminent Member
Joined: 17 years ago
Posts: 47
 
controller should always be put on inspection before clearing any faults/resetting GCIO360 board allowing system to boot back up properly. Single reset, double reset and on a really bad day draining the CAP.



   
ReplyQuote
Share:
Scroll to Top