Elevator Forum

Changed main sensor board. Aux sensor board and DZR switch. Learn run worked Car is running good Thanks for all input guys

It happens a few seconds after moving car off bottom limit.

Or maybe the door zone reed switch

I got communication after hooking all original boards and software back up. Now I’m trying to do learn run and getting a 10 fault on selector. Pulse c...

55 ohms between psc and nsc. And they are not grounded out.

I will be back early tomorrow morning to see if they read to ground.

Its front door openings only. I. do have spares. But they are shielded. Not sure if have spares like that in tc Should I disconnect Psc and nsc in mac...

Yes I have plugged in all ports. Toc machine room and Car panel . I read between psc and nsc. Watchdog led is steady red on clc. Selector board and do...

85. ohms across PSC and NSC. Power supply is good Last edited by Tech9; 12/04/19 07:15 PM.

I hooked up my fast tool to car station ..I had no response from device I unplugged all connections to CLC besides the top connector and still had no ...

I have one light on the vertical board lit. The error light. No cpu light

I only took the vertical board with me. . I only worked on the crip board replacing the relay. I can’t imagine what happened to the cpu vertical board...