Elevator Forum

That was it! Found TIP 1.1.22 explains the adjustment Thanks.

Received the IO board back from Unitec, Now is will not energize the R relay which pulls in UCMX. Meaning rope gripper will not reset what is keeping ...

This is a five car group. We sent the IO board tomorrowBe repaired, thinking it was a faulty IO. None of the other cars go on FS. And we changed the R...

Now the car seems to be on FS, kills the hall riser with FS key switch, All COP buttons and Indicators are dead. Doors will open with DO button. Repla...

The Batteries were approaching the replacement date. We replaced all the batteries. Wait and see now.

Yes, it goes through process, but fails with 847 fault. The car runs terminal to terminal with out faults, fails to save TBS.

We have 2 cars identical machines and GOV. Intermittently get a 1613/1509 fault. The car that runs without issues has P16=252. This car has P16=245.. ...

On a relay logic controller the reopen circuit is separate than a actual hall call. So the Elevaor is not reopening the door when sitting at the floor...

I have the same issue, on a 3 stop duplex. I will hold the car call, close the doors but not run or reopen doors unless a hall call is registered. Cha...

Yes , we have had 3-4 jobs SD cards fail. MCE will warranty exchange the SD cards.