Elevator Forum

Found the solution. Purchased the Gen2 programmer and, while not inexpensive at $1,600, it took about 2mins to navigate through the menus to enable fl...

ABE thanks, and yes I have spoken to folks at American Access and Access2parts. Access is who gave me the part number for the programming device. I th...

Board needs to be programmed/configured with PN 2900501 which is the Thyssenkrupp Access LEV Gen2 programmer. Best information I have is that this was...

COP board replaced. Same result. I think I am done. Will start hunting for someone locally that worked on these things 10 years ago in the Charlotte a...

Even with bypassing interlocks and changing out the call station patch cables, same result. Spoke with an engineer at KEB and based on a description o...

Controller & drive are all located at the top of the elevator shaft on 4th floor. Accessible via an access panel. Posted a link to a pic of the el...