Elevator Forum

Had the same faults on a job and it ended up being the belt tension from the motor...

I just had a pretty similar problem recently. When I arrived the car would answer calls but had no door operation... When I tried operating the doors ...

Do you have an air charged muffler that is out of air and is vibrating due to the empty bladder inside the muffler? Just a thought...

Is there any rubber/neoprene isolation between the piston and car sling? As much as it doesn't seem like it would do anything...it does.

Probably a good one to call Motion about...if you haven't already.

The resistor is a 39k ohm 1/8 watt SMDFound this handy web site that has good info/calculator.

BTW the EcoSpace is not limited to 150 fpm...It is available at 200 fpm also.

Try this link to see photo...the original host/forums/ubbthreads.php?ubb=showgallery&Number=3890#Post3890Seems all 330A's have an issue with R176 ...

Originally Posted By: RGray Respectful correction to comments above...OHIO and MONTANA are not nicknames of the products. They were the R&D design...

Has anyone successfully repaired this resistor? If so...did you merely re-solder the existing one or replace with something else? I've seen this issue...

Order the larger 25amp version from spares...its well worth the extra cost. G14 at end of part # instead of G13.

Ohio and Montana nicknames are given to the first state to pilot the particular product.

The EcoSpace also known as...the Ohio(4:1), the Montana(2:1), and now called the MonoSpace STD(standard), all use the MX10(smaller machine). The MonoS...

Definitely open the drive up and check the connections inside...seen several with just loose connections inside. Also have you tried just having it re...