Elevator Forum

I mean repacking the internals on twin post telescopic is fun enough off the cartop with a 30 foot fall. No way I'd wanna do that hanging the car at t...

To be honest I don't know in particular about a Miconic A, never had to work on one. I was just thinking of what I'd be checking first if I was in you...

By checked the braking resistors, do you mean megged them? Did you megger the motor yet?

What happens if you disconnect the motor wires and try to run it?

But I would recommend Canton. Even in a telescopic jack or inground. They are top notch quality packages. Installing canton reminds you of the good ol...

Honestly, they fill a niche. But unless there's a reason you can't drill, you'll probably be better off with a regular in ground hydro. Then you don't...

Invest in a good pipe clamp or Jerry rig some v notched 4x4 or 6x6s, and 2 good strap wrenches. Rigid makes some monster strap wrenches.

I would recommend a va controls mh3000 to go with it

Use the search feature on this one, someone asked this awhile ago and I gave pretty detailed answers on it. Overall they are good solid units. But the...

Ill email what I got

Yeah, your over thinking this. It's just a series circuit with a break somewhere. Just find the bad lock part or wire and replace it. And most certain...

Sounds good, whatd yall find?

No workaround really. Once you find it you gotta do what you gotta do. But at least its not an outdoor rack and pinion car at a PowerPlant with the wi...

I would put it on inspection in the controller, jump that intermediate lock circuit to verify its the intermediate locks. REMOVE the jumper then put o...

Dirt nailed it. I've found over the years you can have jobs where GAL rollers have been installed for 20 years and eventually the doors will start to ...