Elevator Forum

I'll bet there's a problem in the leveling unit..

When they (PS1) go, they go. In my experience, most every time I've lost one it was after I killed the power to replace a module or do something simpl...

Disconnect the L and N wires on PS1 and see if you still pop a fuse...

Yep, they only have so many power ups. Disconnect the card rack fan to make sure but it's probably the PS1. I've replaced lots of them.

I think it's LIM = Limit

I'd like to see a Composite without a selector cable and pie plates... Vator is correct, there is a reflective tape for the DZ at each floor and a DZ ...

Check the resistance and mechanal operation of your T69 and all of your up limit switches.

Yes, always remember: D=outputK=input

Electric stop? Is it working?

Smitty is correct, is there a SIMM card in the slot?

No need for a CADI to do either.

Eeco?

What is Eco?

You need to tune the regulator output. PM me your email, I may have that write up.

I guess it's ok to unplug without turning off then. Have to turn it on, no choice.