Notifications
Clear all
Topic starter
28/10/2009 6:25 am
Selenium Rectifier in O & W Controller
We had a lot of intermittent problems with an O & W car because of a 50 to 70 volt control voltage drop when the doors opened. It turned out to be a bad selenium rectifier feeding the main control voltage. The rectifier must have been breaking down internally causing a large voltage drop under load.
You can just replace the selenium rectifier with a postage stamp rectifier as shown in the controller image. You should read about 200 to 210 VDC if the rectifier is good.
You can just replace the selenium rectifier with a postage stamp rectifier as shown in the controller image. You should read about 200 to 210 VDC if the rectifier is good.
14/11/2009 11:41 pm
I had a similar problem on an Otis car with touch buttons. The touch buttons were acting up not latching and causing a lot of intermittent calls. It turned out to be a bad selenium rectifier that was not putting out enough voltage. Once the rectifier was changed the problem went away.