i need to upgrade varidor 10 car doors with Fermatoor vvvf car doors, SDIC is Q3. attaching the bords photo, on the link below
Any help regarding wiring and collecting the signals for new car doors would be appreciated 🙂
i know everything about fermator, but i don't have documentation regarding SDIC.Q3 i mean where from to collect open and close door signals.
In that case you dont have a DOD PCB where you can choose your type of door machine. So I think I would remove the 3 main power phases of the X400 plug on the SDIC PCB and use the relays ST-S and ST-O to generate my open and close signals to the Fermator door controller. Remember to connect the door open limit (KET-O XKET Pin 2-5) and door close limit (KET-S XKET Pin 3-4) signals to the plug XKET on the SDIC PCB. The Schindler controller is very sensitive about these signals. You can connect the door reopen signal from the door controller in the same plug (KSKB XKET Pin 1-6).
No, i dont have the schematics ☹️
In that case you dont have a DOD PCB where you can choose your type of door machine. So I think I would remove the 3 main power phases of the X400 plug on the SDIC PCB and use the relays ST-S and ST-O to generate my open and close signals to the Fermator door controller. Remember to connect the door open limit (KET-O XKET Pin 2-5) and door close limit (KET-S XKET Pin 3-4) signals to the plug XKET on the SDIC PCB. The Schindler controller is very sensitive about these signals. You can connect the door reopen signal from the door controller in the same plug (KSKB XKET Pin 1-6).
Yes Alex, it is Smart Mrl, and there is no DOD PCB.
Thanks for helping me.
In that case you dont have a DOD PCB where you can choose your type of door machine. So I think I would remove the 3 main power phases of the X400 plug on the SDIC PCB and use the relays ST-S and ST-O to generate my open and close signals to the Fermator door controller. Remember to connect the door open limit (KET-O XKET Pin 2-5) and door close limit (KET-S XKET Pin 3-4) signals to the plug XKET on the SDIC PCB. The Schindler controller is very sensitive about these signals. You can connect the door reopen signal from the door controller in the same plug (KSKB XKET Pin 1-6).
Yes Alex, it is Smart Mrl, and there is no DOD PCB.
Thanks for helping me.
No worries, feel free to post again, if you have any futher questions.
/Alex
Big thanks to Alex75 who helped with great explanation.
Attaching some photos.
https://ibb.co/fDDMvA
https://ibb.co/iV9daA
https://ibb.co/nHOt8V
Cheers !!!!!
Big thanks to Alex75 who helped with great explanation.
Attaching some photos.
https://ibb.co/fDDMvA
https://ibb.co/iV9daA
https://ibb.co/nHOt8V
Cheers !!!!!
What a mess. Maintenance man needs shooting.
Big thanks to Alex75 who helped with great explanation.
Attaching some photos.
https://ibb.co/fDDMvA
https://ibb.co/iV9daA
https://ibb.co/nHOt8V
Cheers !!!!!
What a mess. Maintenance man needs shooting.
You are right, not exactly for shooting but enough for being punished.
Any way that photo is taken during figuring out how to do it, it is sorted later 🙂