I am looking for technical information about the jumper settings on a TMI2 elevator controller board.
Does anyone have documentation, service manuals, schematics, or technical notes describing the function of each jumper on the TMI board?
I am particularly interested in:
- The purpose of each jumper.
- Hardware configuration options controlled by the jumpers.
- Whether any jumpers affect software configuration or available motor types.
- Any jumper settings related to board initialization, EPROM configuration, or controller setup.
The reason for my question is that I am troubleshooting a system where a replacement TMI board does not behave exactly like the original one. After transferring the EPROM (27C1001) from the original board, parameter P40 on the CPI programmer only shows a limited motor selection and does not allow selection of DAF210.
Therefore, I am trying to determine whether the available motor types and controller configuration depend only on the EPROM contents or if some jumper settings on the TMI board also play a role.
Any documentation, board photos with jumper descriptions, manuals, or personal experience would be greatly appreciated.
Thank you.
What is in the event stack?
F051218 Flash Version
The event stack is empty and there are no active faults.
The interesting part is that after moving the original 27C1001 EPROM from the old TMI2 board to the replacement board, parameter P40 only offers a limited motor selection and the DAF210 motor type is no longer available.
This is why I am trying to determine whether the motor list depends only on the EPROM contents or if it is also affected by firmware, onboard flash memory, or hardware configuration/jumper settings on the TMI2 board.