Elevator Forum

I believe the mechanic just puts it on inspection to reset. have not been there yet, was just looking for a clue before i go. being lazy ha ha

think there website changed to www.liftwares.ir

well only lasted 3 days and same thing, at a loss now, everything seems ok, but still this problem persists. uggg dam elevators

sorry whadafack see the py3 now thinking of pa series. need to pay attention ha ha

be careful, the door comm port is a rs485 port, if you hook up your 232 cord, you could ruin your tool, if there is 24 volts on the 485 port pins. get...

well otis does sell the HVIB board. We obtained one, and got car running again. so far so good no faults, but time will tell. the DOLD relays are rly1...

thanks guys, it is a gcs controller. i believe that we cleared the drive fault log, and when we duplicated problem, the drive fault log was still empt...

probably took out all the boards. it is possible.

thanks jkh , did not get your email, however got car running. replaced cop2 board and all went well. we ended up backing off of the jack bolt under ca...

also like CSL indicates there is another trick, if you unplug the connectors at the door and selector, you leave the connector on that goes to the por...

so any of the mentioned calls do not cancel when at that floor? if the calls don't cancel, they will not drop out ca. , if they are not cancelling, ma...

thanks ken, so what do u need cable wise to connect laptop to system ? trying to picture it in my mind, do you use the serial port? then plug into the...