Elevator Forum

did you find one, i may have one. let me know

thanks for the close out. i think all the guys appreciate when the post is finalized.

we have put in around 50 of the traction cars, we have had some cars running for a couple years now with no trouble calls, which is quite impressive. ...

access has fixed ours and do a great job, however M421 is telling you to check the fault log in the drive for further info. you plug into drive and pr...

yes need service tool,

solid think you said you were getting a C1 error code on the mcvinst5 board i sent you a message regarding this. I believe you said the error code on ...

if you have a ovf30 drive, there is a setting in the drive menu to tell the controller if there is a brake switch or not. you can turn it off temporar...

send me a pm with your email

you can get UIT from vertical express. i got mine there, blaze it is the UIT for the door operators, and works on all door operators, not on the contr...

i think so. did you go to the website

you can use the UIT to manually input the door profile parameters. i have the various door profiles on disk, and use the adapter tool to load them ont...

i have replaced a few of these, and i always downloaded the generic software that i got from a buddy. However one of my employees recently had to repl...

Its oil and grease account. I have very limted knowledge of this equipmentWe told them to contact kone. Could not justify wasting there money on board...

so as low oil suggested, i did a lon download, hall calls came back up, i then had to do a shaft setup, on the shaft set up, i took it to bottom floor...

power supply may be crowbarring. when you arrive, check power supply 1 for 120 vac input, if it has 120v and the 5, or 12 output supply is 0, then you...