Elevator Forum

Thank you Smitty for all the advice.Will see how it go tomorrow.Thanks,

Thank you Nelson!I check it out tomorrow.Thanks,Ken

update:Turn out the problem is faulty DCL sensor on the new board. But for some reason, I still cannot do the learn on the door by setting the travel ...

Hi Jim:serial# HC20926Sales # 425524WD# 15-1 S/F7900 ASDate: 94-08-12my email address [email protected]Thanks,Ken

Will do,Thanks

no uit. still not getting it to learn and the door status still showing setup. leave elevator in service for now with note said that "don't worry abou...

procomm plus with Wyse 50 settingyou can use it for replacing your terminal

It happen to me before also, the trust bearing went bad. Repair mechanic replace the trust bearing and the packing but pull the motor in too much and ...

The size and mounting is completely different. you need to make sure you have enough room for the new drive. Also, need to drill and tap new mounting ...

I do have some, let me know what you are looking for.

Thank you very much!!

Hi Rodney:Don't see the PM.Can you re-send it?Thanks,