Elevator Forum

Elevator has been running for the past 2 hours with no drive faults or shut downs. After changing the DPP2 sensor and adjusting the DP2 magnet inside ...

I changed my DPP2 sensor and I am now reading my velocity and direction correctly on the INIT block of the wizard and rvu which is a great sign. Gonna...

Talked to another guy who had this issue. He says it’s the dpp sensors sending feedback. I’m going back tomorrow to change the sensors and will post h...

Yes I have a laptop and rvu on the job. I trapped the faults I got rid of 43 but it’s still reading as if the car is moving when it’s floor level. I c...

Doesn’t seem like this problem is shutting down my car. I was able to catch it trip out on a drive fault and seem like the lock is being tipped or gat...

Do you still have a wiring diagram for a Langley power lift? If so my email is [email protected]

Not sure. I have a pic of the cover but no print number

Last company to have the job ripped off all information on co triller and took the prints. Only info I found on controller was it has a direct logic 0...

Im looking for a procedure to either run a learn on a conquest elevator or how to restore my floor count

looking for help to run a learn on a conquest elevator, my plc screen is reading "there are no floor levels set"